Mobotix T24 Informazioni Techniche Scaricare il pdf (Pagina 72)

72/118

T24 System Manual Part 2: Access Conﬁguration On The Keypad

www.mobotix.com • [email protected]

3.4.3 Change PIN

You require the user’s old and new PINs to change an access PIN previously set up for a

user. The personal number of the user to whom the access PIN may have been assigned

during the original setup is not required.

Proceed As Follows:

1. Select the new access PIN and immediately make a note of it on your T24 User Data

Record Card (see 3.2.2). The new access PIN also needs to have at least four and

no more than 16 digits, and it may not consist of zeros only.

2. Enter Conﬁguration Mode: Press the OK/MENU button until you hear the second

beep (button ﬂashes blue).

3. Hold your admin card up to the keypad buttons until you hear a beep and the

OK/MENU button lights up blue continuously.

4. Enter Access Conﬁguration Mode: Brieﬂy press the blue key button, which then

lights up blue.

5. Enter old PIN: Enter the previous access PIN and brieﬂy press the blue key button

(button ﬂashes blue).

6. Enter new PIN: Enter the new access PIN and brieﬂy press the blue key button

(button ﬂashes blue). Re-enter the new access PIN for conﬁrmation and brieﬂy

press the blue key button (button lights up blue). A beep sounds and the keypad

displays a ﬂashing ring pattern.

hold (2nd beep)

0 9

Access PIN

0 9

Access PIN

0 9

Access PIN

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 119 120

Nessun commento

Mobotix T24 Informazioni Techniche Pagina 72