Mobotix T24 Informazioni Techniche Scaricare il pdf (Pagina 106)

106/118

T24 System Manual Part 2: System Restore

www.mobotix.com • [email protected]

5.2.4 Exchanging T24-Info2wire+ Components

The T24’s two-wire cabeling set always consists of two devices:

the outdoor station’s T24-Info2wire+ info module and a second

indoor unit installed inside the building.

When you exchange them, the door station’s power supply is

disconnected automatically. The door station is automatically

ready for operation again once the power supply has been

reconnected. A system restore is not required.

Proceed As Follows:

1. Disconnect the door station and T24-Info2wire+ com

ponents from the power supply.

Remove the T24-Info2wire+ info module to be exchanged

from the module frame as described in the T24 System

Manual Part 1/Section 2.4.6 (Removing And Exchanging Modules).

3. Exchange the old info module and indoor unit with the new devices. Take care not

to damage the cabling or mix up the connections. The connection diagrams are

provided in the T24 System Manual Part 1.

4. Power up the system again. After an automatic reboot, the door station is ready

for operation again.

Notes

The two T24-Info2wire+ units are matching pairs and preconﬁgured at the factory.

Matched units share the same network ID (see labels on the back of the info module

and on the indoor unit’s circuit board). In case of a defect, both units must always be

exchanged for a new Mx2wire pair that has been conﬁgured by MOBOTIX and shipped

in its original packaging.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 119 120

Nessun commento

Mobotix T24 Informazioni Techniche Pagina 106