Mobotix T24 Informazioni Techniche Scaricare il pdf (Pagina 32)

32/118

T24 System Manual Part 2: System Startup Without A PC

www.mobotix.com • [email protected]

2.2.2 Add Admin Card

It is also necessary to set up the admin card during the initial

startup of the keypad, in addition to the Super PIN. The card

is required as a “T24 master key“ for authentication purposes to

allow you to set up and erase user cards and user access PINs

and specify important system settings (time, changing the Super

PIN) on the keypad.

You should keep the card in a safe place together with your T24

User Data Record Card. MOBOTIX recommends only using your blue user cards to avoid

losing your safety-critical admin card for everyday use (open the door, access your voice

mailbox from the keypad and so on).

General Information On Using Transponder Cards

When setting up a transponder card, you should ideally hold the card between the

thumb and index ﬁnger of one hand and move it as close as you can to the keypad

until a beep sounds. Make sure that the card does not touch and inadvertently trigger

any of the buttons.

During daily operation, you can usually hold the user card up to the keypad while it is

still in its protective case or in your wallet.

You can enter your Super PIN and press the OK/MENU button to avoid having to hold

the admin card up to the keypad. However, for security reasons (people looking over

your shoulder), you should only use this special function in an emergency, for example,

if you have lost your admin card.

Add Admin Card:

Once you have entered your Super PIN, the number buttons on the keypad light up white

continuously, the keypad bell button, key button and OK/MENU button ﬂash blue and

the ESC/ALARM button ﬂashes red. You must set up the supplied red admin card on the

keypad and add it to the system while the keypad is in this state.

Hold your admin card up to the keypad buttons for about 5 seconds until the beeping

stops and the keypad shows a ﬂashing ring pattern.

2. Afterwards, the bell button, key button, OK/MENU button and ESC/ALARM button

all ﬂash blue on the keypad. Your admin card has now been set up and automatically

assigned the Personal and Transponder No. 0 by the system.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 119 120

Nessun commento

Mobotix T24 Informazioni Techniche Pagina 32