Mobotix T24 Informazioni Techniche Scaricare il pdf (Pagina 12)

12/118

T24 System Manual Part 2: Overview Of Application Scenarios

www.mobotix.com • [email protected]

1.2 Advanced Scenario

1.2.1 Advanced Access Control

Multiple user cards or an additional access PIN can be assigned to each user with advanced

access control. These assignments, which are made based on a personal number when

the cards/PINs are registered in the system, make it possible to quickly and easily remove

users from the system at a later time.

Setup Cards Using The Keypad

The user cards are included with your MOBOTIX product. These cards allow you to enter

the building without the need for a key and enable you to operate the voice mailbox using

the keypad. However, the cards must ﬁrst be registered in the system before they can be

used. To set up a new user card, use the red admin card for authentication, enter a special

key combination and then simply hold the card up to the keypad.

Setup With Automatic Number Assignment

The system automatically assigns two numbers to each new card for quick and easy

setup: a personal number and a transponder number. The personal number represents

the owner of the card. Using the transponder number, it is possible to erase a card from

the system, even when the card is not available (for example, if it is stolen or misplaced).

The transponder number is the current number of the card, which sequentially increases

along with the total number of cards registered in the system.

The system automatically assumes that each user card will be assigned to a dierent

user. Therefore, in this simpliﬁed system operation, the system automatically assigns

personal number 1 and transponder number 1 to the ﬁrst blue user card to be registered.

The system then assigns personal number 2 and transponder number 2 to the second

blue user card, etc.

The red admin card has a special status in the system. This card is used to carry out special

administrative and conﬁguration tasks. The admin card automatically receives personal

number 0 and transponder number 0 from the system.

Automatic assignment of personal numbers and transponder numbers when registering

the transponder cards using the keypad:

Personal number Transponder number

Serial card number

Admin card 0 0 Printed on card

First user card 1 1 Printed on card

Second user card 2 2 Printed on card

Third user card 3 3 Printed on card

Fourth user card 4 4 Printed on card

... ... ... ...

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 119 120

Nessun commento

Mobotix T24 Informazioni Techniche Pagina 12